Page 7 - Arrow Shark E-Starer V4 Owner Manual

Insert the upper plum coupling through the 57T gear, and Insert the coupling shaft through the lower bearing on the
use two C-clips to hold it in place. Make sure they are two CNC plate as shown above, and use a C-clip to hold the
8mm C-clips here in order to make out the proper space shaft in place.
between the gear and the CNC plate. Note: When doing this, the Logo side should be facing you.

Install the 13T shaft gear through the upper Use the C-clip to hold the gear shaft in place.
bearing on the CNC plate.

Insert the 35T gear onto the shaft on 13T gear Apply some grease in the gap of each tooth
shaft and use a C-clip to hold it in place. on 35T gear as shown above.

7