Page 7 - Arrow Shark Blade-X Owner Manual

Slide the trim shaft (#C) through center hole of copper bush (#D), Install the copper bush along
with the trim shaft into the angle adaptor (#E), secure the copper bush inside of the angle adaptor by
tighten the M3 hex nut (#F) into the slot on the copper bush. screw the M5 nut č#BĎonto the trim
shaft at near thread end spot, then, screw trim shaft assembly into the trimming cylinder (#A) until
against the M5 nut, you can adjust the propeller thrust angle by screw in or out the trim shaft, after
reaching your prefer thrust angle, fasten the M5 nut to set the angle firmly in place.

Install the center trimming cylinder onto
the top of the main body, and matching
the installation holes, secure them with
supplied M4 bolt and nut.

7