| [Manufacturer] | Arrow Shark |
| [Product Version] | GTM-1V Gear Box |
| [Product Weight] | 725 Gram |
| [Product Dimension] | Please check the dimension picture above for the detail. |
| [Brief Description] | The GTM-1V Gear Box is an upgraded version of our very succeed GX-1M Gear Box that we released 5 years ago, as we always believe that there is no Best, only Better! With the great experience we have from GX-1M, plus years of concluding performance feedbacks from GX-1M, we extremely proud to introduce this improved version of GTM-1V gear box which delivers stronger, lighter, and better structure design.
The main components of GTM-1V gear box are precision-engineered and manufactured with up-to-date CNC technology, it has a lustrous external finish whilst careful internal machining of any low-stress areas has removed surplus metal and reduced any unnecessary weight to reach its unmatched performance and provides sufficient room for the lubrication oil. All drive shafts made of high quality stainless steel to prevent the corrosive and rusty, GTM-1V comes with three detachable shaft collets also made of stainless steel, and the flexible shaft for the connection between engine and GTM-1V shaft input, The two output collets will accept any 1/4 inches (6.35mm) diameter flexible shaft. The gears inside the box has lighten hollowing out design and manufactured with technology of compacting process of powder metallurgy the same technology used for gears in full size automotive transmissions, the new gears delivers more rigidity and much lighter in weight compare to the gears in GX-1, and these gears were supported by total 8 heavy-duty ball bearings via the harden drive shafts, this results in ultra smooth operation and enable to handle any gas or electric motor over 15HP with up to 25000RPM+ without failure. The GTM-1V Will suit both Gas Engine or Electric Brushless Motor with any mono hull application from 55 inches up to 75 inches. GTM-1V Gear Box will be shipped to you fully assembled and ready for installation into your next gas boat project. Please Note: The Gear Box will be shipped to you without pre-filling the lubrication oil, you will need to fill the lubrication oil after you receive it. Any brand of 4 stoke oil or gear oil will work. |
100%
0%
0%
This site is protected by copyright and trademark laws under US and international law.
all rights reserved ©2019-2029 Arrow Shark Inc
Most helpful comments（3）
Have bought both versions of this monohull Gearbox (just to try each), impressive appearance, engineering looks good too. Easy to install. One drives out to a pair of Stinger drives, the other to a twin-set of Arrow Shark Blade-X Arneson drives. Both in Delta Force 53-inch Annihilator hulls. Covid restrictions mean neither has been run yet, looking forward to trialling various props.
Specification
[Manufacturer]Arrow Shark[Product Version]GTM-1V Gear Box[Product Weight]725 Gram[Product Dimension]Please check the dimension picture above for the detail.[Brief Description]The GTM-1V Gear Box is an upgraded version of our very succeed GX-1M Gear Box that we released 5 years ago, as we always believe that there is no Best, only Better! With the great experience we have from GX-1M, plus years of concluding performance feedbacks from GX-1M, we extremely proud to introduce this improved version of GTM-1V gear box which delivers stronger, lighter, and better structure design.
This is a great piece of cnc red.